CYBEX XP4010 Guide de l'utilisateur télécharger pdf (Page 18)

For PS/2-style keyboard, monitor and PS/2 mouse

1. Your user interface cables for these peripherals will be labeled either

CPIU-x or CPIUF-x , depending on the options you ordered. Use the cable

diagrams below to locate the correct cable.

2. At your secondary console, plug your PS/2-style keyboard, PS/2 mouse

and monitor connectors into the matching connectors on the user interface

cable. The mouse connector is denoted by a yellow band around its cable.

If you have the CPIUF-x series cable, you will have three additional

connectors: two small connectors for a microphone and speakers, and a 9-

pin D shaped serial connector for a serial port. The microphone connector

is denoted by a blue band around its cable. Plug your peripheral connec-

tors into the matching connectors on the user interface cable.

3. Attach the user interface cable to the unit by plugging the 62-pin connec-

tor into the rear of any available secondary console module. Ensure that

the connector is firmly seated, then tighten the thumbscrews.

VGA VIDEO

KEYBOARD

SPEAKERSMICROPHONE

(blue band)

SERIAL PORTPS/2 MOUSE

(yellow band)

KEYBOARD

VGA VIDEO

PS/2 MOUSE

(yellow band)

CPIU-

CABLE CPIUF-

CABLE

NOTE: You may use your SGI, RS/6000 or HP workstation monitor with an

XP4000 Series unit if it will function with all of your attached computers/

workstations. See “Using Non-multisync Monitors” later in this chapter.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 156 157

Pas de commentaire

CYBEX XP4010 Guide de l'utilisateur Page 18