CYBEX XP4010 Guide de l'utilisateur télécharger pdf (Page 20)

For Sun keyboard and mouse

1. Your user interface cables for these peripherals will be labeled either

CWSU-x or CWSUF-x , depending on the options you ordered. Use the

cable diagrams below to locate the correct cable.

2. At your secondary console, plug your Sun keyboard/mouse and VGA

monitor connectors into the two matching connectors on the user inter-

face cable.

If you have the CWSUF-x series cable, you will have three additional

connectors: two small connectors for a microphone and speakers, and a 9-

pin D-shaped serial connector for a serial port. The microphone connector

is denoted by a blue band around its cable. Plug your peripheral connec-

tors into the matching connectors on the user interface cable.

3. Attach the user interface cable to the unit by plugging the 62-pin connec-

tor into the rear of any available secondary console module. Ensure that

the connector is firmly seated, then tighten the thumbscrews.

NOTE: You may use your Sun monitor with an XP4000 Series unit if it will

function with all of your attached computers/workstations. See ‘Using Non-

multisync Monitors’ later in this chapter.

CWSU-

CABLE CWSUF-

CABLE

KEYBOARD/MOUSE

VGA VIDEO

KEYBOARD/

MOUSE

MICROPHONE

(blue band)

SPEAKERS

SERIAL PORT

VGA VIDEO

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 156 157

Pas de commentaire

CYBEX XP4010 Guide de l'utilisateur Page 20