CYBEX AUTOVIEW COMMANDER - Guide de l'utilisateur télécharger pdf (Page 17)

Attaching Multiple AutoView 424 Units

(Please note that CIFCM cables are required for cascading.)

1. Follow steps 1-8 of the Basic Install section for each cascaded unit.

2. Plug the 25-pin “mini-D” connector of your CIFCM input cable into any

available channel port on the rear of your base AutoView 424 unit.

3. Plug the 15-pin video connector on the other end of the cable into the

port labeled

on your first cascading AutoView 424 unit. Plug the

PS/2 mouse connector into the

port. Plug the remaining 6-pin

miniDIN keyboard connector into the

port.

4. Repeat steps 2-3 for every cascaded AutoView 424 unit in your system.

5. Follow steps 9-11 of the Basic Install section to attach compters to the system.

6. Power-up your AutoView 424 unit(s) first, then all attached computers.

Installation

Advanced Install

CASCADING

UNIT

BASE UNIT

VGA MONITOR CABLE

PS/2 MOUSE CABLE

PS/2 KEYBOARD CABLE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Pas de commentaire

CYBEX AUTOVIEW COMMANDER - Guide de l'utilisateur Page 17