CYBEX AUTOVIEW COMMANDER - Guide de l'utilisateur télécharger pdf (Page 26)

AutoView 424 Installer/User Guide

Basic Channel Maintenance is performed from the Administrator Command

Menu, and is available if you are operating in non-secure mode or if you are the

system administrator. Here you can add, delete or edit individual channels.

Adding Channels

1. Select ‘Add Channel’ from the Administrator Command Menu or press

the Insert key. Type in a new channel name, up to 14 characters long,

and press Enter.

2. Type in the address for the computer you are naming and press Enter.

Please note that the address cannot be longer than two digits. (For

cascaded addresses see ‘Keyboard Switching’ in Chapter 3.)

3. Enter the dwell time for the ID Window and press Enter.

4. Enter the dwell time for scanning and press Enter.

5. After selecting “ID Setup”, use the arrow keys to position the ID window

where you would like it to appear when this channel is selected. Then

press Enter. (For further information see ‘The ID Window’ later in

this chapter.)

Press Esc at any point to exit this operation without adding the channel.

Basic Channel

Maintenance

THE ADD CHANNEL WINDOW

Scan Dwell Time 5

CYBEX Control Panel

Add Channel

Name

Address

ID Dwell Time 5

ID Setup

Save Changes

ENTER = activate ESC = exit

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

Pas de commentaire

CYBEX AUTOVIEW COMMANDER - Guide de l'utilisateur Page 26