CYBEX TROTTER Manuel de service Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 108
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
Stopping the Treadmill
Press Stop once to pause your workout for 20 seconds (default setting) and to enter the
Workout Review. The belt will stop and the elevation will return to 0%, but all workout
settings and data will remain in memory for the pre-selected time. Press the Quick Start key
within 20 seconds to continue your workout at the speed and elevation where you left off. If
the Quick Start key has not been pressed during the 20 second pause, workout data will be
cleared and the display will change to Dormant Mode.
Press Stop a second time to interrupt workout data from cycling and to change the display to
Dormant Mode.
The function of the immobilization method: The purpose
of immobilizing the treadmill is to prevent unauthorized use.
This can be accomplished by removing the e-stop key from
the console, unclipping it from the cord and putting it in a
non-accessible place. See Figure 2.
The emergency dismount: Follow the steps listed below if
you experience pain, feel faint or need to stop your treadmill
in an emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key functions as
the emergency stop. In an emergency situation, remove the e-stop key and the treadmill will
come to a stop. On the console, the e-stop location looks like Figure 3.
Safety Sentry
If you step off your treadmill during a workout, it may detect that you are not there. After the
pre-selected waiting period “run?” will appear in the center window for a few seconds then
Safety Sentry™ will stop the belt. If you press Quick Start within the time selected you can
resume your workout. NOTE: If you are less than 100 lbs. and you are not using Polar the
treadmill may not detect you are there and cause the treadmill to come to a stop. Safety Sentry
is disabled above 11% grade. It can also be disabled by setting SAFE time to “none”. If
changes in elevation or speed occur while you are not there (such as during a programmed
workout) Safety Sentry resets its waiting period.
Cybex TROTTER Elite Treadmill Owner’s & Service Manual
e-stop
+
-
Figure 3
Figure 2
Operation
Page 3-5
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 107 108

Commentaires sur ces manuels

Pas de commentaire