CYBEX TROTTER Manuel de service télécharger pdf (Page 73)

4. Adjust the speed sensor gap (if needed).

A. Using a Phillips head screwdriver, loosen the screw that attaches the speed sensor to

the motor saddle. See Figure 3 (speed sensor screw).

B. Adjust the gap between the speed sensor and the flywheel to 3/16” (.48 cm) and

tighten the screw. See Figure 3.

5. Test for speed errors.

A. Connect the power cord to a power outlet.

B. Enter Test Mode.

C. Bring the speed of the treadmill up to maximum speed, 10 mph (16 kph).

D. After reaching maximum speed take note of the actual speed that is displayed in the

lower left window. If it fluctuates in over 0.5 mph increments then your speed sensor

gap needs to be readjusted.

E. Press Stop and turn the power switch to the off (O) position.

F. Enter Test Mode again and check the error log for Error 3. If any new errors occurred,

readjust the speed sensor and test again. NOTE: If you are unsure whether an error is

new you can clear the error log by pressing the key and then repeat steps 4A

through 5F.

G. Exit Test Mode by pressing Stop.

6. Attach the motor cover.

A. Lower the motor cover center into position. See Figure 2.

B. Using a Phillips head screwdriver, tighten the three screws on each side.

Cybex TROTTER Elite Treadmill Owner’s & Service Manual

Figure 3

Gap

Speed Sensor Screw

Flywheel

Service

Page 7-7

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 107 108

Pas de commentaire

CYBEX TROTTER Manuel de service Page 73