CYBEX LT-16602-4 Manuel de service télécharger pdf (Page 36)

A. With the treadmill running at 5 mph (8 kph) observe the running belt. If the belt tracks

off center to the right or left the deck will become exposed. Use a 3/4” socket wrench

to tighten the rear roller bolt on the side of the treadmill toward which the belt is

moving. For example: If the belt moves to the right and the deck becomes exposed on

the left, tighten the bolt on the right side of the frame, tighten about 1/2 of a turn

(clockwise) and wait 30 seconds. If the belt does not move back to the center of the

treadmill, make another adjustment to the same bolt. Once the running belt has been

adjusted closer to the center of the treadmill use about 1/4 of a turn until the belt has

been stabilized.

B. After the belt has been centered, check the belt tension again. Make sure the running belt

tension is tight enough so that the belt does not slip or hesitate when stepped on. Walk

on the treadmill at 3.5-4 mph (5.6-6.4 kph) and every 4th to 5th step throw your weight

into your step to feel if the belt is slipping. If the belt does slip, use a wrench to equally

tighten both rear roller adjustment bolts 1/2 of a turn (clockwise). Adjust the belt until no

further slipping is felt. If the running belt continues to slip the drive belt could be loose.

Checking the Belt and Deck Surfaces — The running belt and deck should be checked

periodically for any excessive wear. In an effort to make sure that the running belt operates

properly, visually inspect the belt often to make sure that there are no tears or fraying in the

belt material.

Inspect the edges of the belt as described below. NOTE: It is necessary to remove the motor

cover and plastic side panels.

Tools Required

• Phillips head screwdriver

• Dry towel

1. Disconnect the external power source.

A. Turn the main power switch on the left side to the off (O) position.

B. Unplug the treadmill from the

power outlet.

2. Remove the motor cover.

A. Using a Phillips head screwdriver,

loosen three screws on each motor

cover side (left and right). See Figure 2.

B. Lift the motor cover up and off the

treadmill. The screws will stay in

place. See Figure 2.

3. Remove the end caps.

A. Using a Phillips head screwdriver,

remove the screw that holds each

end cap in place. See Figure 3.

Cybex Sport Treadmill Owner’s & Service Manual

Figure 2

Screws

(3 Each Side)

Motor

Cover

Preventive

Maintenance

Page 4-4

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 97 98

Commentaires sur ces manuels

Pas de commentaire

CYBEX LT-16602-4 Manuel de service Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course CYBEX LT-16602-4