CYBEX LT-16602-4 Manuel de service télécharger pdf (Page 86)

Cybex Sport Treadmill Owner’s & Service Manual

B. Using a Phillips head screwdriver, remove the three screws that hold the bottom back

cover to the console front.

C. Gently pull off the console backs. NOTE: The bottom back will have delicate wires

attached to it. Do not apply pressure to it.

3. Remove the display board.

A. Disconnect these cables from the display board: the display cable (2 connectors), the

two upper switch membranes, the lower switch membrane, the contact heart rate

cable and the upper to lower board jumper. See Figure 24.

B. Using a Phillips head screwdriver, remove the four Phillips head screws that hold the

display board to the console.

C. Gently pull the display board up to disconnect it from the CSAFE board.

4. Attach the display board.

A. Place the display board in position and gently push the display board down into the

CSAFE board connector.

B. Using a Phillips head screwdriver, secure the four screws that hold the display board

to the console.

CSAFE Board

Connects to

Display Board

Upper Display Board

Lower Display Board

Contact Heart

Rate Port

Lower Switch

Membrane

Upper to

Lower Board

Jumper

Upper Switch Membrane Ports

Heart Rate

Board

Display Cable Ports

Figure 24 NOTE: Sport models before October 2002 did not have the CSAFE board and RJ-45 port.

Early models of the upper display overlay did not have switch membranes.

RJ-45 Port

CSAFE

Jumper

Service

Page 7-30

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 97 98

Pas de commentaire

CYBEX LT-16602-4 Manuel de service Page 86