CYBEX LT-16602-4 Manuel de service télécharger pdf (Page 67)

Cybex Sport Treadmill Owner’s & Service Manual

4. Remove the side panels.

A. Pull each side panel out and off the treadmill. See Figure 5.

5. Remove the top steps.

A. Using a Phillips head screwdriver, remove the three screws that hold one of the top

steps in place. Repeat this step for the other side. See Figure 5.

B. Grasp each top step and slide it out and off the treadmill. See Figure 5.

Rear Roller

6. Remove the rear roller.

A. Using a 3/4” open end or socket wrench,

loosen the two rear roller bolts (one roller

bolt on each side). NOTE: Loosen each

bolt evenly, making sure not to loosen

either bolt too many turns before moving

to the other bolt. See Figure 6.

B. While holding the rear roller, remove the

hardware from each side. NOTE: Pivot

the bolt, washers, spring and nut holder

out together. See Figure 6.

C. Lift one side of the rear roller and slide

the roller out of the running belt. See

Figure 6.

Figure 6

Rear Roller Bolt, Washers, Spring and

Nut Holder

NOTE: Keep the Hardware Together

Rear Roller

Side Panel

Figure 5

Side Panel

Top Steps

Running Belt

Screws (3 Under

Each Top Step)

Service

Page 7-11

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 97 98

Pas de commentaire

CYBEX LT-16602-4 Manuel de service Page 67